Cut Files Your Cutter Accepts, With Proof Every Part Matches
Drop a DXF. Square Edge finds the gaps, duplicate lines, splines and layer problems that get files rejected, fixes the ones that are safe to fix, and checks every part against your source file.
DXF R12 to 2018 · inch or metric
or drop it here. It is read on this computer and never uploaded.
Files stay local · units never guessed · audit to 0.0001 in
Read live by the engine in your browser
The 1% Stretch
A plate stretched by one percent looks right on screen and on a nested sheet. On a 36 inch part it comes off the table more than a third of an inch long. Square Edge measures every edge, hole and distance against your source and stops the job if anything changed.
How It Works
Eight steps · one screen at a timeLoad
Loose parts or whole nests, several files at once. See what they hold before anything changes.
Check
Every issue, numbered on the part, with its size.
Fix
Safe fixes within tolerance, each measured and logged. You decide the rest.
Set Up
Identical parts matched across files, even when turned. Part numbers and quantities.
Nest
Re-nest on the plate sizes you choose, with remnants kept. Plate use compared with your old nest.
Audit
Every part measured against the source to 0.0001 in, and every sheet checked part by part.
Package
Fixed part DXFs, nested sheet DXFs, PDF previews, a parts list and the Verified Report.
Verify
Your cutter checks the package for free. Any change shows up.
All eight steps run in the beta, in your browser.
The Verified Report
Every package carries a report with each part's measurements and a fingerprint of its exact geometry. It holds numbers, not drawings, so you can share it without sharing your design.
See How Verify Works| Part | Size | Holes | Fingerprint |
|---|---|---|---|
| Part 1 | 36.000 × 10.000 | 7 | sha-256 per part |
| Package | every file hashed | sha-256 | |
Layout shown for illustration. Real reports come out of the Package step.
For Cutting Shops
Check incoming files and verify Square Edge packages free. Publish your file requirements as a profile so your customers send files you can cut the first time.
For CuttersPricing
Checking and verifying are free. Fixing is 10¢ a part and fixing with nesting 20¢ a part, paid per job from a balance with no subscription needed. Pro is $39 a month.
See PricingOpen Contours And How To Close Them
Why a cutter rejects an outline that does not close, how big a gap is too big, and what is safe to close automatically.
Layer Setup For Cut Files
Four layers, colored ByLayer, so the cutter knows what to cut, what to mark and what to read.
Units Without Guessing
How a DXF states its units, why the header is often wrong, and how to make sure a part is cut at its real size.