Skip to content
Square Edge

Guides

Draft

Open Contours And How To Close Them

A cutter follows an outline from start to end. If the end does not meet the start, the machine has no closed path to cut, and most cutters reject the file or cut it wrong.

Where gaps come from

  • Lines drawn separately that almost meet, often from snapping that missed by a hair.
  • Exports from 3D models that break curves into short pieces.
  • Old drawings that were scaled, so endpoints moved by tiny amounts.

How big is too big

Square Edge closes gaps up to the profile tolerance, 0.001 in by default. Closing a gap that small moves an endpoint less than a human could ever measure on the part, and every closure is measured and logged.

A gap larger than the tolerance is left open and shown to you. It may be a real opening, or a drawing mistake that needs a person to decide. Square Edge never guesses.

How to fix it in your CAD

  1. Zoom in on each end of the open outline.
  2. Join the ends with your CAD's join or fillet command, or redraw the short piece.
  3. Check that the outline now reports as closed.

Or drop the file into Square Edge: the check shows each gap with its size, and the free fix closes the ones within tolerance.