Draft
Spacing And Small Features By Process
Every cutting process removes a width of material and needs room between cuts. Holes that are too small for the process and the thickness come out tapered, rough or not at all.
Starting values
| Process | Part spacing | Smallest hole |
|---|---|---|
| Laser | 0.125 in | about 0.5 × thickness |
| Plasma | 0.250 in | about 1.5 × thickness |
| Waterjet | 0.125 in | about 0.5 × thickness, and at least 0.060 in |
| CNC router | 0.500 in | about 0.5 × thickness, and at least 0.125 in for the tool |
These come from public guidelines. Each process profile page lists its sources.
The cutter's numbers win
Machines, gases, nozzles and bits differ. When your cutter publishes their own spacing and minimum hole size, use theirs. Square Edge profiles can carry each shop's values.
Small holes you still need
If a hole is below the minimum for the process, mark it on MARKING as a drill point instead of cutting it, and say so on INFO.