Skip to content
Square Edge

Guides

Draft

Preparing Files For A Plasma Table

Plasma tables are forgiving machines with fussy controllers. Most problems at the table start in the file.

The checklist

  • Closed outlines. An open contour makes the torch stop, or cut a line it should not.
  • True arcs, not splines. Many plasma controllers read splines as hundreds of short lines, which slows the torch and roughens the edge.
  • R12 DXF. Many older controllers read R12 best. Square Edge writes R12 for the plasma profile.
  • Holes at least 1.5 × thickness. Smaller holes come out tapered. On 0.250 in plate, that is a 0.375 in hole or larger.
  • Spacing for the kerf. Leave at least 0.250 in between parts unless your table's own number is different.
  • Clean layers. Outer profiles on CUT, holes on INSIDE CUT, marking and text kept off the cut layers.

Check it before the table

Drop the file into Square Edge with the plasma profile. The check lists anything on this page that is missing, and the free fix handles the gaps, duplicates and splines within tolerance.