Process profile
Plasma · built from public guidelines
Plasma · built from public guidelines
Generic Plasma
Starting values for plasma cutting, from public guidelines. Set your cutter's own requirements where they differ.
| Requirement | Value |
|---|---|
| Part spacing | 0.250 in |
| Smallest hole | 1.5 × thickness |
| Smallest slot width | 1.5 × thickness |
| Tiny segment limit | 0.005 in |
| Cleanup tolerance | 0.001 in |
| DXF version written | R12 |
| Lineweight | as drawn |
Sources
- https://www.hypertherm.com/resources/system-support/maintenance-and-use/cut-quality/hole-quality/ — holes under 1.5x thickness are 'small holes' with reduced quality
- https://www.kjellberg.de/holes — rule of thumb: smallest hole about 1.5x plate thickness
- part_spacing_in 0.25: no authoritative public figure found; Square Edge starter value — set your cutter's requirement
- dxf_version R12: many older plasma controllers read R12 best; Square Edge starter value