Skip to content
Square Edge
Process profile
Laser · built from public guidelines

Generic Laser

Starting values for laser cutting, from public guidelines. Set your cutter's own requirements where they differ.

RequirementValue
Part spacing0.125 in
Smallest hole0.5 × thickness
Smallest slot width0.5 × thickness
Tiny segment limit0.005 in
Cleanup tolerance0.001 in
DXF version writtenR2000
Lineweight0 (required)

Sources

  • https://sendcutsend.com/blog/understanding-small-geometry-in-laser-cutting/ — holes, slots and cutouts about 50% of material thickness
  • https://xometry.com/resources/sheet/sheet-cutting-tips — feature spacing capped at 0.125 in; used as the part spacing starter value
  • Lineweight 0: common requirement of older laser controllers; Square Edge starter value

Check Your File Against This Profile